Filter
Top Products
6 English
The scope of delivery of your appliance is il-
lustrated on the packaging. Check the con-
tents of the appliance for completeness
when unpacking.
In the event of missing accessories or any
transport damage, please contact your
dealer.
Illustrations on Page 2
1 Coupling element for water connection
2 High pressure connection
3 ON/OFF switch for appliance
4 Detergent Tank
5 Storage for trigger gun
6 Dosage regulator for detergent
7 Suction hose for detergent
8 Transport handle
9 Storage for accessories
10 Power cable with plug
11 Connection for water supply with filter
12 Trigger gun
13 Lock trigger gun
14 High pressure hose
15 Spray lance with pressure regulation
(Vario Power)
16 Spray lance with Dirtblaster
17 Washing brush
Special accessories expand the possibilities
of using your appliance. Please contact your
KÄRCHER dealer for further information.
Illustration
Mount loose parts delivered with appliance
prior to start-up.
Illustration
Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
Check the secure connection by pulling
on the high-pressure hose.
ṇ Warning
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to the
water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Screw the coupling element (supplied)
to the water connection on the appli-
ance.
Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
Caution
Dry runs lasting longer than two minutes
lead to damages to the high pressure
pump. If the appliance does not build up
pressure within two minutes, switch it off
and proceed as instructed in the Chapter
"Troubleshooting".
Operation
Scope of delivery
Description of the Appliance
Special accessories
Before Startup
Water supply
Water supply from mains
Start up