Filter
Top Products
English 5
This product is supplied with a Ground
Fault Circuit Interrupter (GFCI) built into
the power cord plug. This device provi-
des additional protection from the risk of
electric shock. If power is interrupted in
the line, the GFCI will automatically re-
close the circuit to the load after power
is restored. Depending on the GFCI mo-
del, it may be necessary to manually
operate the reset button to restore po-
wer to the GFCI load circuit. If replace-
ment of the plug or cord is needed use
identical replacement parts.
ƽ CAUTION
Dirt in the feed water will damage the
unit. To avoid this risk, we recommend
fitting a water filter.
! Water hose must be at least 5/8 inch
in diameter.
! Flow rate of water supply must not
fall below 2 GPM (gallons per minu-
te).
! Flow rate can be determined by run-
ning the water for one minute into an
empty 5-gallon container.
! The water supply temperature must
not exceed 104°F/40°C.
! Never use the pressure washer to
draw in water contaminated with sol-
vents, e.g. paint thinners, gasoline,
oil, etc.
! Always prevent debris from being
drawn into the unit by using a clean
water source.
SAVE THESE
INSTRUCTIONS!
" STEP 1:
" STEP 2:
" STEP 3:
" STEP 4: Attach the high pressure
hose to the trigger gun.
Pull out the locking slide from the
right side of the trigger gun handle
(A), and insert the small end of the
high pressure hose into place (B).
Push the locking slide back into the
trigger gun (C) to lock the hose in po-
sition (D).
GROUND FAULT CIRCUIT IN-
TERRUPTER PROTECTION
WATER SUPPLY
(Cold Water Only)
ASSEMBLY INSTRUCTIONS