Filter
Top Products
9
Deck Cleaning
(with or without detergent)
Pre-rinse deck and surrounding area with
fresh water. If using Kärcher Deck and Patio
Cleaner, place detergent suction tube direct-
ly into cleaning solution and apply to surface
at low pressure. For best results, limit your
work area to smaller sections of approxi-
mately 25 square feet. Allow Kärcher Deck
and Patio Cleaner to remain on surface 1-3
minutes. Do not allow detergent to dry on
surface. Rinse at high pressure in a long
sweeping motion keeping the spray nozzle
approximately 3-6 inches from the cleaning
surface. Always clean from top to bottom
and from left to right. When moving on to a
new section of the cleaning surface, be sure
to overlap the previous section to eliminate
stop marks and ensure a more even clean-
ing result.
House Siding
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
If using Kärcher House or Window and
Siding Cleaner, place detergent suction tube
directly into cleaning solution and apply to
surface at low pressure (for best results,
limit your work area to sections of approxi-
mately 6 feet and always apply detergent
from bottom to top). Allow Kärcher House or
Window and Siding Cleaner to remain on
surface 1-3 minutes. Do not allow detergent
to dry on surface, if surface appears to be
drying, simply wet down surface with fresh
water. If needed, use special Wash Brush
Attachment to remove stubborn dirt. Rinse
at high pressure from top to bottom in an
even sweeping motion keeping the spray
nozzle approximately 6 inches from the
cleaning surface.
CLEANING TIPS
Cement Patios, Brick and Stone
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
If using Kärcher Deck and Patio or All
Purpose Cleaner, place detergent suction
tube directly into cleaning solution and apply
to surface at low pressure. For best results,
limit your work area to smaller sections of
approximately 25 square feet. Allow Kärcher
Deck and Patio or All Purpose Cleaner to
remain on surface 1-3 minutes. Do not allow
detergent to dry on surface. Rinse at high
pressure in a sweeping motion keeping the
spray nozzle approximately 3-6 inches from
the cleaning surface. Always clean from top
to bottom and from left to right.
Cars, Boats & Motorcycles
(with or without detergent)
Pre-rinse vehicle with fresh water. If using
Kärcher Vehicle or All Purpose Cleaner,
place detergent suction tube directly into
cleaning solution and apply to surface at low
pressure. For best results, clean one side of
vehicle at a time and always apply detergent
from bottom to top, do not allow detergent to
dry on surface. If needed, use special Wash
Brush Attachment to remove stubborn dirt.
Rinse at high pressure in a sweeping motion
keeping the spray nozzle approxi-mately 6-8
inches from the cleaning surface (distance
should increase when rinsing pin-striping or
other sensitive surfaces). Always clean from
top to bottom and from left to right. For best
results, wipe surface dry with a chamois or
soft dry cloth.
CARE AND MAINTENANCE INSTRUCTIONS
Cleaning the water inlet filter
Pull out the water inlet filter with flat-nose
pliers and rinse out in warm water.
Maintenance
The unit is maintenance-free.