Filter
Top Products
4
Step 6
Slide the throttle
control to the run
position.
Step 7
Push the
primer ball three
times. Wait 3 seconds
between each push.
Note: in cold weather
push 5 times.
Step 8
Pull the starter handle. If
the engine fails to start after 3 pulls
squeeze the trigger gun to release
pressure, and repeat step 8.
OPERATING INSTRUCTIONS
Step 1 Connect the high pressure hose to
the unit’s high pressure outlet.
Step 2 Insert the spray wand into
the wand extension. Push in and turn
clockwise to lock spray wand in place.
Step 3 Connect
garden hose to unit’s
water inlet.
Step 4 Connect
garden hose to the
cold water source
and turn water on
completely.
Step 5 Trigger the gun to
eliminate trapped air, wait for a
steady flow of water to emerge
from the spray nozzle.
No tools required.
You are now ready
to operate your
Karcher 3000 G
Pressure Washer.
3
ASSEMBLY INSTRUCTIONS
Step 1
Attach the handle to the frame of the
pressure washer. Align holes, insert bolt, and
tighten with knob.
Step 2
Slide the wand extension
into the gun. Turn the wand collar
clockwise onto the gun threads
until tight.
Step 3
Check oil level. Oil level should always
be between the “FULL” and “ADD” marks on the
dipstick. Be sure the machine is level when check-
ing the oil level. (Refer to the engine’s operating
manual for seasonal grades.)
Step 4
Fill gas tank with unleaded
gasoline. Do not use leaded gasoline.
Important!
Do not run the engine with
a high or low oil level as this can cause
engine damage. If you have further ques-
tions regarding the engine, please refer to
the engine’s operating manual included
with the unit.
K3000G Manual 11/30/01 4:56 PM Page 4