Filter
Top Products
4
IMPORTANT PRECAUTIONS – continued
• Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
NOTE: Dirt in the feed water will
damage the unit. To avoid this risk,
we recommend fitting a water filter.
• Always prevent debris from being drawn into
the unit by using a clean water source and an
accessory water filter if required.
Water Supply (Cold Water Only)
• Water hose must be at least a 1/2 inch or
5/8 inch in diameter.
• Flow rate of water supply must not fall
below 2 GPM (gallons per minute).
• Flow rate can be determined by running the
water for one minute into an empty 5-gallon
container.
• The water supply temperature must not
exceed 104°F/40°C.
ASSEMBLY INSTRUCTIONS
Step 1
Assemble the mobile
adaptor by aligning
the four holes to the
machine. Tighten each
of the four short
screws provided.
Step 4
Assemble the handle
by aligning the holes
to the handle posts.
Insert two of the long
screws and tighten.
Step 2
Slide the two handle
posts into the mobile
adaptor and line up
the holes. Insert two
of the long screws
and tighten.
Step 3
Insert wheels into side
holes of the mobile
adaptor and snap into
place.
Step 6
Place the filter end of
detergent suction tube
into the detergent
container.
Step 5
Assemble the
detergent container.
Step 7
Pull out the locking
slide from the right
side of the trigger gun
handle.
Insert the small end of
the high pressure
hose into place.
Push the locking slide
back into the trigger
gun to lock the hose
in position.