Filter
Top Products
4
Water Supply (Cold Water Only)
• Water hose must be at least 3/4 inch in
diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running the
water for one minute into an empty 5-gallon
container.
Step 1
Pull out the locking slide from
the right side of the trigger
gun handle.
Step 2
Insert the small end of the
high pressure hose into place.
IMPORTANT PRECAUTIONS – continued
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
• Always prevent debris from being drawn
into the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
Step 3
Push the locking slide back into
the trigger gun to lock the hose
in position.
Step 4
Connect the detergent suction
tube to the pressure washer.