Filter
Top Products
4
Step 5
Slide the throttle control to the
fast position.
Step 7
Pull the starter handle. If the
engine fails to start after 3 pulls squeeze
the trigger gun to release pressure, and
repeat step 7.
OPERATING INSTRUCTIONS
Step 1 Connect the high pressure hose
to the unit’s high pressure outlet.
Step 2 Connect garden
hose to unit’s water inlet.
Step 3 Connect garden
hose to the cold water source
and turn water on completely.
Step 4 Trigger the gun to eliminate trapped air, wait
for a steady flow of water to emerge from the spray noz-
zle.
You are now ready to
operate your K
ä
rcher
Pressure Washer
3
ASSEMBLY INSTRUCTIONS
Step 1
Slide the handle through
the accessory rack.
Step 3
Check oil level. Oil level should
always be between the “FULL” and “ADD”
marks on the dipstick. Be sure the machine is
level when checking the oil level. (Refer to the
engine’s operating manual for seasonal
grades).
Step 4
Insert the detergent tray into the
tray slot and screw in the fastener. Fill the
detergent container with the proper deter-
gent for you cleaning project. Note: Place
the container on the tray.
Important!
Do not run the engine
with a high or low oil level as this can
cause engine damage. If you have fur-
ther questions regarding the engine,
please refer to the engine’s operating
manual included with the unit.
Step 5
Fill gas tank with unleaded
gasoline. Do not use leaded gasoline.
Step 2 Attach the gun/hose
storage handle.
NOTE: Engines controls shown may appear different.
Step 6
Push primer ball three times.
Wait 3 seconds between each push.
Note: in cold weather push 5 times.