Filter
Top Products
6 English
Î
STEP 1:
Connect the high pressure hose to
the unit’s high pressure outlet.
Î STEP 2:
Insert the spray wand of your choice
into the trigger gun. Press in against
the spring tension and twist into
locked position.
Î STEP 3:
Connect garden hose to unit’s water
inlet.
Î STEP 4:
Connect garden hose to the cold wa-
ter source and turn water on com-
pletely.
Î STEP 5:
Plug the Ground Fault Circuit Inter-
rupter (GFCI) into a working outlet.
– Press “RESET” button.
– Press “TEST” button.
Red indicator on “RESET” button
should appear.
– Press “RESET” button again for use.
ƽ WARNING
Do not use if above test fails.
Note: The actual appearance of the GFCI may
be different from this illustration.
Î STEP 6:
Unlock the Safety lock. Trigger the
gun to eliminate trapped air, wait for
a steady flow of water to emerge
from the spray nozzle.
Î STEP 7:
Turn on the high pressure washer (I).
The motor starts only if the trigger
of the gun is pulled and shuts off
when the trigger is released.
OPERATING INSTRUCTIONS