Filter
Top Products
English 5
This product is provided with a ground-
fault circuit interrupter (GFCI) built into
the plug of the power-supply cord. This
device provides additional protection
from the risk of electric shock.
Should replacement of the plug or cord
become necessary, use only identical
replacement parts that include GFCI
protection.
Contact Kärcher Customer Support.
ƽ CAUTION
When connecting the water inlet to the
water supply mains, local regulations of
your water company must be observed.
In some areas the unit must not be con-
nected directly to the public drinking wa-
ter supply. This is to ensure that there is
no feedback of chemicals into the water
supply. Direct connection via a receiver
tank or backflow preventer, for example,
is permitted.
Dirt in the feed water will damage the
unit. To avoid this risk, we recommend
fitting a water filter.
Garden hose must be at least 5/8
inch in diameter.
Flow rate of water supply must not
fall below 2 GPM (gallons per minu-
te).
Flow rate can be determined by run-
ning the water for one minute into an
empty 5-gallon container.
The water supply temperature must
not exceed 104°F/40°C.
Never use the pressure washer to
draw in water contaminated with sol-
vents, e.g. paint thinners, gasoline,
oil, etc.
Always prevent debris from being
drawn into the unit by using a clean
water source.
Screwdriver, small size (not supplied)
for connecting high pressure hose and
trigger gun.
Î STEP 1:
Connect the detergent suction tube
to the pressure washer.
Î STEP 2:
Attach the high pressure hose to the
trigger gun.
A Pull out the locking slide from the
right side of the trigger gun handle.
B Insert the small end of the high pres-
sure hose into place.
C Push the locking slide back into the
trigger gun to lock the hose in posi-
tion.
GROUND FAULT CIRCUIT INTER-
RUPTER PROTECTION
WATER SUPPLY
(Cold Water Only)
ASSEMBLY INSTRUCTIONS
Required tools
Assembly