Filter
Top Products
ASSEMBLY INSTRUCTIONS –
continued
OPERATING INSTRUCTIONS
43
Water Supply
(Cold Water Only)
• Water hose must be at least 3/4 inch in
diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
IMPORTANT PRECAUTIONS –
continued
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
• Always prevent debris from being drawn
into the unit by using a clean water source.
• Save these instructions!
ASSEMBLY INSTRUCTIONS
Step 3 Slide the handle into the top
slot of the wheel carriage and snap into
place.
Step 4 Slide the trigger gun holder
into track on the right hand side of the
pressure washer.
Step 2 Place the wheel carriage
onto the mounting brackets on the sides
of the washer and align the four holes.
Snap into place.
Step 1 Insert wheels into side holes at
the bottom of the pressure washer and snap
into place.
Step 3 Connect garden hose to the cold
water source and turn water on completely.
Step 4 Plug the power cord into the
power outlet. Trigger the gun to eliminate
trapped air, wait for a steady flow of water
to emerge from the spray nozzle.
Step 2 Connect the garden hose to the
water inlet.
Step 1 Connect the high pressure hose
to the high pressure outlet.
Step 5 Pull out the
locking slide from the right
side of the trigger gun han-
dle, and insert the small end
of the high pressure hose
into place. Push the locking
slide back into the trigger
gun to lock the hose in
position.
Step 6 Insert the Spray Wand Extension into the trigger
gun. Press in against the spring tension and twist into the
lock position. Turn the Spray Wand Extension Collar clock-
wise until tight. Note: spray wand extension must be
attached to use accessories.
Step 7 Attach quattro nozzle for four different
spray settings.
K1400 electric 6/27/02 6/27/02 10:01 AM Page 4