Filter
Top Products
4
Step 5
Slide the throttle control to the fast
position. Move the choke lever to the “CHOKE”
position (only if the engine is cool). After starting,
move the choke to “RUN”. Turn fuel valve to “ON”.
Step 6
Pull the starter handle. If
the engine fails to start after 3 pulls
squeeze the trigger gun to release
pressure, and repeat step 6.
OPERATING INSTRUCTIONS
Step 1 Connect the high pressure hose
to the unit’s high pressure outlet.
Step 3 Connect garden hose to
the cold water source and turn water
on completely.
Step 2 Connect garden hose to unit’s
water inlet.
Step 4 Trigger the gun to eliminate trapped air,
wait for a steady flow of water to emerge from the
spray nozzle.
Tools required. adjustable pliers.
3
ASSEMBLY INSTRUCTIONS
Step 6
Check oil level. Oil level should be
to the oil filler neck. Be sure the machine is
level when checking the oil level. (Refer to the
engine’s operating manual for seasonal grades.)
Step 7
Fill gas tank with unleaded
gasoline. Do not use leaded gasoline.
Important!
Do not run the engine with a high or low oil level as this can cause
engine damage. If you have further questions regarding the engine, please refer to the
engine’s operating manual included with the unit.
Step 1 Tilt machine back-
wards slightly (caution: oil may
leak if tilted too far).
Attach the
front guard to the frame. Align
holes, insert bolt and tighten
with lock nut.
Step 4
Attach the triple jet nozzle to the
spray wand.
Step 5
Attach the spray wand to the
trigger gun.
Step 2
Attach the handle
to the frame of the pressure
washer. Align holes, insert bolt,
and tighten with knob.
Step 3
Attach high
pressure hose to
trigger gun.
K7000G Manual 11/30/01 5:04 PM Page 4