Filter
Top Products
English 13
You can remedy many faults yourself by us-
ing the following overview.
If in any doubt, please contact the author-
ised customer service.
ƽ Risk of electric shock
Always switch off the appliance and pull out
the mains plug before care and maintenance
work.
ƽ Warning
Repair works may only be performed by the
authorized customer service.
Machine does not start
" Check whether the voltage indicated on
the type plate corresponds to the voltage
of the socket.
" Check the power cord for damage.
Pressure does not build up in the appli-
ance
" Check the setting at the spray lance.
" Evacuate air from the appliance: Switch
on the appliance when the HP hose is
not connected and allow it to run until the
water which discharges from the HP out-
let is free of bubbles. Then connect the
HP hose again.
" Clean the filter in the water supply con-
nection: This can be easily removed us-
ing flat-nose pliers.
" Check all supply lines to the HP pump for
leaks or blockages.
Strong pressure fluctuations
" Clean the high-pressure nozzle: Re-
move dirt and debris from the nozzle
bore with a needle and rinse through with
water towards the front.
" Check the volume of incoming water.
HP pump leaking
" Slight leakage from the HP pump is nor-
mal. If the leakage increases contact the
authorized customer service.
No detergent infeed
" Clean the filter of the detergent suction
hose.
" Select the low-pressure setting for the
spray lance.
Call: 01-800-024-13-13 for help or visit our
website: www.karcher.com.mx
Faults
Specifications
Max. Pressure 1400 PSI
Water volume 300 l/h
Amp draw 10 AMPS
Voltage 127 V / 60 Hz
Part No. 1.601-105.0
Serial no.
Kärcher Customer Support
Mexico