Karcher G 2500 VH Pressure Washer User Manual


 
English 11
All Kärcher pumps ship with oil already
inside direct from the factory. There is
no need to add oil.
You should routinely make a visual in-
spection of the pressure washer’s
pump. If you notice oil leaking around
the pump seals, you should take the
pressure washer to a Kärcher-Autho-
rized Service Center for repair. (You
can locate a service center in your area
online at www.karcher-usa.com/ser-
vice.)
The pump on your Kärcher pressure
washer does not require maintenance.
Any attempts to service or alter the
pump may damage your pressure
washer and void your product warranty.
Carry out maintenance tasks for the en-
gine according to the specifications pro-
vided in the operating instructions
provided by engine manufacturer.
(with or without detergent). Pre-rinse
deck and surrounding area with fresh
water. If using Kärcher Deck Wash, ap-
ply to surface at low pressure. For best
results, limit your work area to smaller
sections of approximately 25 square
feet. Allow Deck Wash to remain on sur-
face 1-3 minutes. Do not allow deter-
gent to dry on surface. Rinse at high
pressure in a long sweeping motion
keeping the spray nozzle approximately
3-6 inches from the cleaning surface.
Always clean from top to bottom and
from left to right. When moving on to a
new section of the cleaning surface, be
sure to overlap the previous section to
eliminate stop marks and ensure a more
even cleaning result.
CAUTION
Do not use Dirtblaster spray nozzle
on wood surface as it may cause
damage.
(with or without detergent). Pre-rinse
cleaning surface with fresh water. If us-
ing Kärcher Pressure Wash, apply to
surface at low pressure (for best results,
limit your work area to sections of ap-
proximately 6 feet and always apply de-
tergent from bottom to top). Allow
Pressure Wash to remain on surface 1-
3 minutes. Do not allow detergent to dry
on surface, if surface appears to be dry-
ing, simply wet down surface with fresh
water. If needed, use special wash
brush attachment (not included) to re-
move stubborn dirt. Rinse at high pres-
sure from top to bottom in an even
sweeping motion keeping the spray
nozzle approximately 6 inches from the
cleaning surface.
CAUTION
Do not use Dirtblaster spray nozzle
on siding as it may cause damage.
MAINTENANCE INSTRUCTIONS
Kärcher pump
Initial Use
Pump Inspection
Pump Maintenance
Engine
CLEANING TIPS
Deck Cleaning
House Siding