Filter
Top Products
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 9
Safety shut-off
The pump automatically shuts down for safety
reasons if the handgun is neither opened or
closed for more than 30 minutes.
– To switch it on again turn the main switch to
"0" and then back to the "I" position.
(The EPROM without disabling 6.682-595.0 is
available from service)
EACH TIME AFTER USAGE
Following operation with cleaning agent
– Set the cleaning agent metering valve
(item 31) to "0"
– Set the unit switch (item 23) to "I"
– Actuate handgun and flush unit for
approx. 1 min
Stopping machine
– Set the unit switch (item 23) to "0"
– Shut off water supply
– Switch the pump briefly on with the unit switch
(item 23) (approx. 5 sec.)
– Remove mains plug from socket ONLY with
dry hands
– Detach water connection
– Actuate handgun to depressurise unit
– Lock the hand spray gun Figure 8
– Engage spray lance in cover holder
– Reel up the high-pressure hose and electric
cables and attach them to fastenings
* Take care not to kink high-pressure hose and
cable!
Frost will destroy unit if water is not drained off
completely!
Store unit in a frost-free location
Take unit out of service if frost-free storage is
not possible.
READING THE OPERATING HOURS
(ONLY HDS 995 AND HDS 1295)
When you open the storage compartment cover
flap,you will notice the electronic operating
hours display in the viewing window, e.g.
= 245 hours.
DISCONTINUATION OF USAGE
In the event of lengthy periods of non-use or if
frost-free storage is not possible:
– Drain off water and flush out equipment with
antifreeze
– Drain cleaning fluid tank
Drain off water
– Unscrew water supply hose and high-
pressure hose
– Unscrew supply line at boiler base and allow
heating coil to drain
– Run unit for max. 1 min until pump and lines
are empty
Flushing unit with anti-freeze
– Fill the float tank with a commercially
available antifreezing compound
– Swith the unit on (without the burner) until it is
thoroughly purged
– Observe handling instructions of antifreeze
manufacturer
– By this means, a certain degree of corrosion
protection is achieved
MAINTENANCE
* Disconnect unit from mains before carrying
out any maintenance or repair work.
* Always use genuine spare parts
Shut off unit before performing any work, refer
to AFTER USE.
Set the unit switch (item 23) to "0"
Pull power plug out of socket
Shut off water supply
Actuate handgun to depressurise unit.
Detach water connection
Allow unit to cool down
Please consult your Kärcher dealer for
details of regular safety
inspection/maintenance agreement
Maintenance intervals
Once a week
– Clean strainer in water connection
– Check oil level
Contact Kärcher AFTER-SALES SERVICE
immediately if oil is opaque!