Filter
Top Products
3
ASSEMBLY INSTRUCTIONS
Step 3 Attach the reel
to the handle. Align holes,
insert bolts, and tighten
with nuts.
Step 2 Attach the
gun/hose storage handle.
Step 4 Place the quick
connect nozzles in the
nozzle holder.
OPERATING INSTRUCTIONS
4
Step 9 Connect the
high pressure hose to the
unit’s high pressure outlet.
Step 3
Connect garden
hose to the cold
water source
and turn water
on completely.
Never use hot
water.
Step 4 Trigger the gun
to eliminate trapped air, wait
for a steady flow of water to
emerge from the spray
nozzle.
Step 5 Slide the choke
lever to the left to the “CLOSED”
position (on a warm engine, leave
the choke lever in the open
position).
Step 9 Adjust pressure
control to desired setting.
Step 6 Slide the fuel
valve to the “ON” position.
Slide the throttle lever left
about 1/3 of the way toward
the fast position.
Step 7 Turn the engine
switch to the “ON” position.
Step 8 Pull the starter
handle. If the engine fails to
start after 3 pulls, squeeze
the trigger gun to release
pressure, and repeat step.
After the engine is warm and
running smoothly, slide the
choke lever to the right (open)
and throttle to the left (fast).
Step 6 Pull the spring-
loaded collar of the wand
back to insert your choice
of quick connect nozzle.
Step 7 Release the collar
and push the nozzle until the
collar clicks. Pull the nozzle to
make sure it is seated properly.
Step 8 Attach the
high pressure hose to the
spray gun.
Step 1 Check oil level. Oil level should be level
with the bottom of the oil filler neck. Be sure the
machine is level when checking the oil level. (Refer to
the engine’s operating manual for seasonal grades.)
We recommend that the oil be changed after the first
5 hours of use, then once every 50 hours.
Note: Improper oil levels will cause low oil sensor
to shut off engine.
Step 2
Fill gas tank
with unleaded
gasoline.
Do not use
leaded gasoline.
Step 5 Attach the
wand to the spray gun.
Important!
Do not run the engine with a high or low oil level as
this can cause engine damage. If you have further
questions regarding the engine, please refer to the
engine’s operating manual included with the unit.
Step 10 Connect the
garden hose to unit’s
water inlet.
Step 1 Attach the handle
to the frame of the pressure
washer. Align holes, insert
bolts, and tighten with knobs.
HD3000 Manual 9/20/02 5:28 PM Page 4