Filter
Top Products
English 5
! Avoid tipping the machine on its
side.
SAVE THESE INSTRUCTIONS
ƽ CAUTION
When connecting the water inlet to
the water supply mains, local regula-
tions of your water company must be
observed. In some areas the unit
must not be connected directly to the
public drinking water supply. This is
to ensure that there is no feedback of
chemicals into the water supply. Di-
rect connection via a receiver tank or
backflow preventer, for example, is
permitted.
Dirt in the feed water will damage the
unit. To avoid this risk, we recom-
mend fitting a water filter.
! Garden hose must be at least 5/8
inch in diameter.
! Flow rate of water supply must not
fall below 4.0 GPM (gallons per
minute).
! Flow rate can be determined by run-
ning the water for one minute into an
empty 5-gallon container.
! The water supply temperature must
not exceed 104°F/40°C.
! Never use the pressure washer to
draw in water contaminated with sol-
vents, e.g. paint thinners, gasoline,
oil, etc.
! Always prevent debris from being
drawn into the unit by using a clean
water source.
! Do not operate pressure washer
without the water turned on.
" STEP 1:
Prior to initial startup, cut off tip of oil
reservior cap on the pump.
" STEP 2:
Prior to initial startup, put engine oil
(provided in bottle) in engine before
starting the engine.
For engine details see engine manual.
" STEP 3:
Attach the handle to the frame of the
pressure washer. Align holes, insert
bolts, and tighten with knobs.
WATER SUPPLY
(Cold Water Only)
ASSEMBLY INSTRUCTIONS