Filter
Top Products
ENGLISH -
Unloading the Touch-N-Mow system
Prior to any cleaning or transport operation, the start up
system shall be unloaded.
For this operation, proceed as follows:
- Disconnect the spark plug cable.
- Act on the safety lever (14) ) and keep it pressed against
the handgrip.
- Push the Touch-N-Mow lever (16) forward.
- The motor will run but it will not start as the spark plug
cable is disconnected.
- Turn the Touch-N-Mow key (17) to LOCK & REMOVE
position.
- Remo
ve the key (17).
Start up with Touch-N-Mow
Make sure that no person or object is near the machine and
all protection devices are installed and operating.
Remain behind the handgrip in the position required for
use.
- Insert the key (17) and rotate it to RUN position.
- Act on the safety lever (14) ) and keep it pressed against
the handgrip.
- Push the Touch-N-Mow start lever (16) forward and check
the motor start up.
Caution: i
f the motor does not start, it means
that the Touch-N-Mow start up system has
been unloaded. If so, proceed to load it as
described in the relevant section.
Important: Should
the motor stop due to lack of gasoline,
excessively high grass, or any reason other than the nor-
mal stop procedures, the Touch-N-Mow start up system will
not reload and it will be necessary to repeat the previously
described operations in order to load the system.
ADJUSTMENT OF CLUTCH CABLE (for self-propelled versions only)
Important: If, when you press the clutch lever, the automatic advance gear does not engage, the clutch cable
should be adjusted by inserting the spring (P) in one of the subsequent holes in the plate (R) or in the hole “S” .
AUTOMATIC ADVANCEMENT (for self-propelled versions only)
Periodically check the automatic advance assem-
bly and make sure to keep it clean. In particular,
the pinion (22) and the gear (23) must be kept
perfectly clean.
To carry out this check, you must remove the wheel (24)
by unscrewing the screw (25).
5
MAINTENANCE
Caution! Switch off the motor and disconnect
the spark plug before undertaking any mainte-
nance work.
Cleaning under the bodywork
With machine at a standstill and off.
- Attach fitting (26) on the deck to the water supply tap.
Turn on the tap.
- start up the motor (blade in rotation), allowing it to
warm up for a few minutes.
- at the end of cleaning switch off the motor, turn off the
tap, detach the tube from the deck connection.
VERSION WITH TOUCH-N-MOW
After a garaging period of the machine, it is advisable
to
lubricate the clutch point shown in fig. MII to facilitate
the spring loading procedure.
For a four stroke engine, check the oil level and change
the
oil when dirty. For further explanation, see ENGINE
INSTRUCTION BOOK.
Frequently check the mower and ensure that all grass
deposits are removed from beneath the deck.
Never clean the mower by pouring water over it: this may
seriously damage the electric start system.
Take care, the exhaust muffler may be very hot.
Frequently remove the wheel screws clean whith pe-
troleum and oil before replacing. Ball bearings must be
greased before remounting.
Frequently check the blade for damage.
The lawn mower must be checked by a SERVICE
DEALER.