Jonsered CS 2255 Chainsaw User Manual


 
English – 39
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Jonsered chain saw model CS 2255. The combinations of power head,
bar and chain have been tested and found to be in accordance with the kickback and vibration requirements of ANSI B 175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a hard nose.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which will also
achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar
may be considered to have equivalent or less kickback energy than the sprocket-nose bar.
Bar and chain combinations
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below.
Saw chain filing and file gauges
Bar Chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
13 0,325
0,058
10T
Jonsered H25
56
15 0,325 10T 64
16 0,325 10T 66
18 0,325 10T 72
20 0,325 12T 78
15 3/8
0,058
11T
Jonsered H42
56
16 3/8 11T 60
18 3/8 11T 68
20 3/8 11T 72
16 3/8
0,058
11T
Total NT988PCD
60
18 3/8 11T 68
20 3/8 11T 72
0,050"/1,3 mm - H46 NT980PCD
0,058"/1,5 mm H25 H42 NT988PCD
NT988PCD