Filter
Top Products
38 – English
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Jonsered chain saw models CS 2147 and CS 2152. The combinations
of power head, bar and chain have been tested and found to be in accordance with the kickback and vibration requirements of
ANSI B 175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a hard nose.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which will also
achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar
may be considered to have equivalent or less kickback energy than the sprocket-nose bar.
Bar and chain combinations
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below.
Saw chain filing and file gauges
Bar Chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
13 0,325 0,050 10T Jonsered H30 56
15 0,325 10T 64
16 0,325 10T 66
18 0,325 10T 72
20 0,325 10T 78
13 0,325 0,058 10T Jonsered H25 56
15 0,325 10T 64
16 0,325 10T 66
18 0,325 10T 72
20 0,325 12T 78
0,050"/1,3 mm H30 20BP
0,058"/1,5 mm - H25