Filter
Top Products
32 – English
MAINTENANCE
Cooling system
To obtain the lowest possible running temperature the saw is
equipped with a cooling system.
The cooling system
consists of:
1. Air intake on the starter
unit.
2. Air guide plate.
3. Fan blades on the
flywheel.
4. Cooling fins on the
cylinder.
5. Cylinder cowling
(supplies cold air over
the cylinder).
Clean the cooling system with a brush once a week, more often
in demanding conditions. A dirty or blocked cooling system
results in the saw overheating which causes damage to
piston and cylinder.
Heated handles (2149W)
On the model 2149W both the
front handle and the rear
handle are equipped with
electrical heating coils. These
are supplied with electricity
from a built-in generator in the
electrical system.
When the switch is pushed
upwards, the heat is switched
on. When it is pushed
downwards the heat is
switched off.
1
2
5
4
3
Centrifugal cleaning ”Turbo”
Centrifugal cleaning means
the following:
All air to the carburetor is
carried through the starter.
Dirt and dust is centrifuged
away by the cooling fan.
IMPORTANT! In order to
keep the function of the
centrifugal cleaning, a
continous maintenance and
care must be made.
• Clean the air intake to the
starter, the fan wings of the
flywheel, the space around
the flywheel, inlet pipe and
carburetor space.
H
Winter use
During winter time, snow and cold weather can cause running
problems, such as:
• Too low engine temperature.
• Icing of the air filter and freezing of the carburetor.
Therefore some special measures are required:
• Partly reduce the air inlet of the starter and by doing that
increase the engine temperature.
• Preheat the intake air to the carburetor by using the heat from
the cylinder.
Temperature 0
°C (32°F) or
colder:
The cylinder cover is made so
it can be adjusted for running
in cold weather. Open the
winter flap so that preheated
air from the cylinder can pass
into the carburetor area
preventing for instance icing of
the air filter.
For temperatures below -5°C
(23°F) and/or in snow
conditions there is also:
• a special cover (A) for the
starter housing,
• a winter plug (B) for the air
intake that is fitted as
shown.
These reduce the air flow and
prevent large amounts of snow
from being sucked into the
carburetor chamber. NOTE!
When the winter plug is fitted
the winter flap must be open.
IMPORTANT! If the temperature rises above -5°C (23°F) or 0°C
(32°F) respectively the saw MUST be restored to its normal
settings. Otherwise there is a risk of overheating, which can
cause severe engine damage.
IMPORTANT! Any maintenance other than that described in this
manual must be carried out by your servicing dealer.
H
H