Filter
Top Products
34 – English
0,058"/1,5mm S25,S24,S21,S42 21VB 34LG 21LP 73VL 528PS 988PC
0,050"/1,3mm – – – – 20VB 33LG 20LP 72VL 520PS 980PC
TECHNICAL DATA
2054
3,0/49
1,73/44
1,26/32
2 600
2,2/ 9 600
Electrolux
ET
Champion
RCJ 7Y
0,020/0,5
Walbro
HDA 143
1,18/0,56
4,25-8,5
0,80/0,38
Automatic
11,5/5,2
13-18"/33-48
12-17"/30-43
18,6
0,325"/ 3/8"
0,050"/1,3
0,058"/1,5
7
Recommended original and replacement bar
and chain combinations
Following is a list of recommended cutting equipment for
the Jonsered chain saw model 2054. The combinations of
power head, bar and chain have been investigated in
accordance with the kickback and vibration requirements of
ANSI B 175.1–1991.
The guide bar nose radius is determined by either the
maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
The following list is the chain saw manufacturers
recommendations. There may be other combinations
available, which will also achieve kickback protection.
As we are listing the maximum guide bar nose radius, you
may use a guide bar with smaller nose radius than in our
list. For guide bars of the same length, all sprocket-nose
guide bars of the same pitch and having the same number
of sprocket teeth may be considered to have equivalent
kickback energy. A hard nose bar having the same length
and nose radius as a sprocket-bar may be considered to
have equivalent or less kickback energy than the sprocket-
nose bar.
Low kickback saw chain is a chain which has only met the
kickback performance requirements of ANSI B 175.1 safety
requirements for gasoline powered chain saws when tested
on the representative sample of chain saws below 3.8 cu.
in. specified in ANSI 175.1. We recommend that you as a
replacement use the listed chains or "Low kickback saw
chains" which are available at your dealer.
Engine
Cylinder volume, cu.in/cm
3
Cylinder bore, inch/mm
Stroke, inch/mm
Idle speed, rpm
Power, kW/ rpm
Ignition system
Manufacture
Type of ignition system
Spark plug
Electrode gap, inch/mm
Fuel and lubrication
system
Manufacturer
Carburetor type
Fuel capacity, US pint/litre
Oil pump capacity at
8500 rpm, ml/min
Oil capacity, US pint/litre
Type of oil pump
Weight
Without bar and chain, Lbs/kg
Chain/bar
Recommended bar lengths,
inches/cm
Usable cutting length inches/cm
Chain speed at max. power,
m/sec
Pitch, inches
Thickness of drive link,
inch/mm
Number of teeth on drive
sprocket
Note: For the chains above you are free to choose between 0,050" and
0,058" gauge drive link for the corresponding bar, see the table below.
Guide bar Saw chain
Length Pitch Max nose
inch inch radius
15 0,325 10T Jonsered S25 / S24 / S21 or
16 0,325 10T Oregon 21VB / 34LG / 21LP or
18 0,325 10T Total/Sabre 528PS
15 3/8 11T Jonsered S42 or Oregon 73VL
16 3/8 11T
18 3/8 11T
15 3/8 11T Total/Sabre 988PC
16 3/8 11T
´*xm[¶5M¨