Filter
Top Products
MAINTENANCE
28
MTF-0410122L
AUGER BELT GUIDE ADJUSTMENT
1. Remove spark plug wire.
2. Have someone engage auger drive.
3. Measure the distance between the belt guide and belt.
The distance should be 1/8 inch (3.175 mm) for guide.
See Figure 37.
4. If adjustment is necessary, loosen belt guide mounting
bolt. Move belt guide to the correct position. Tighten
mounting bolt.
5. Reinstall belt cover.
6. Reconnect spark plug wire.
Figure 37
Belt Guide
1/8 Inch (3.17 mm)
Auger Idler
Pulley Engaged
TRACTION DRIVE BELT GUIDE ADJUSTMENT
1. Remove spark plug wire.
2. Have someone engage the traction drive.
3. Measure the distance between the two belt guides and
traction drive belt. Set the distance for the two belt
guides as shown in Figure 38.
4. If adjustment is necessary, loosen belt guide mounting
bolt. Move belt guide to the correct position. Tighten
mounting bolt.
5. Reinstall belt cover.
6. Reconnect spark plug wire.
Figure 38
Belt Guide
1/16 Inch
(1.6 mm)
Traction Drive Idler
Pulley Engaged
Traction
Drive Belt
3/16 Inch
(4.8 mm)
Belt Guide