Filter
Top Products
MAINTENANCE
32
MTF-031033L
HOW TO REMOVE THE SNOW HOOD
To access the spark plug, the snow hood must be removed
as follows:
1. Remove the choke control knob (see Figure 46).
2. Remove the ON/OFF key.
3. Remove the four mounting screws.
4. Slowly remove the snow hood (see Figure 47). Make
sure that the primer button hose and the ignition wire are
not disconnected.
5. To install the snow hood, first make sure that the primer
button hose and the ignition wire are connected.
6. Mount the snow hood to the engine and secure with the
four mounting screws (see Figure 48).
7. Align the tab on the choke control knob with the slot in the
snow hood (see Figure 49).
8. Connect the choke control knob with the choke shaft.
Make sure the choke control knob is properly installed.
If the choke control knob is not installed correctly, the
choke will not operate.
Figure 46
Choke Control Knob
Screws
Screws
Snow Hood
ON/OFF
Key
Figure 47
Snow Hood
Figure 48
Snow Hood
Carburetor
Choke Control
Knob
Tab
Slot
Figure 49