Filter
Top Products
OPERATION
14
MTF-0410102L
The operation of any snowthrower can result in foreign objects being thrown into the eyes,which can
result in severe eye damage. Always wear safety glasses or eye shields before beginning snowthrower
Operation. We recommend standard safety glasses or Wide Vision Safety Mask for over spectacles.
SNOWTHROWER OPERATION
The most effective use of the snowthrower will be established
by experience, taking into consideration the terrain, wind
conditions and building location which will determine the
direction of the discharge chute.
NOTE: Do not blow snow toward a building as hidden
objects could be blown with sufficient force to cause
damage.
TO STOP YOUR SNOWTHROWER
1. To stop throwing snow, release the auger drive lever.
(see Figure 13).
2. To stop the wheels, release the traction drive lever.
3. To stop the engine, push the throttle control lever to off
and pull out the ignition key.
TO CONTROL SNOW DISCHARGE
1. Rotate the crank to set the direction (left to right) of the
discharge chute (see Figure 12).
2. Push the remote chute lever forward to discharge the
snow down. Pull the remote chute lever back to dis-
charge the snow high and far (see Figure 13).
HOW TO MOVE FORWARD AND BACKWARD
1. Start the engine. See “To Start Engine” in the Operation
section.
NOTE: Always release the traction drive lever before
moving the speed select lever.
2. Ground speed is determined by snow conditions. Set the
speed select lever in one of the following positions.
1-2 Wet, Heavy, Slushy, Extra Deep
3 Moderate
4-5 Very Light
6 Transport Only
IMPORTANT: Before operating, make sure the area in
front of snowthrower is clear of bystanders or
obstacles.
3. Engage the traction drive lever (see Figure 13). As the
snowthrower starts to move, maintain a firm hold on the
handles and guide the snowthrower along the cutting
path. Do not attempt to push the snowthrower.
4. To stop forward motion, release the traction drive lever.
5. To move the snowthrower backwards, move the speed
select lever into either first or second reverse position
and engage the traction drive lever.
TO THROW SNOW
1. Push down the auger driver lever (right hand). See
Figure 13.
2. To stop throwing snowl, release the auger drive lever.
NOTE: When clearing wet, heavy snow, it is
recommended that the ground speed of the unit be
reduced, maintain full throttle and do not attempt to
clear the full width of the unit.
For additional operating instructions see “Operating
Tips” in the Operation section.
WARNING: Read Owner’s Manual before oper-
ating machine. This machine can be dangerous
if used carelessly.
Never operate the snowthrower without all guards,
covers, and shields in place.
Never direct discharge towards windows or allow by-
standers near machine while engine is running.
Stop the engine whenever leaving the operating posi-
tion.
Disconnect spark plug before unclogging the impeller
housing or the discharge chute and before making re-
pairs or adjustments.
When leaving the machine, remove the ignition key.
To reduce the risk of fire, keep the machine clean and
free from spilled gas, oil and debris.
Auger Drive Lever
Traction
Drive Lever
Speed Select
Lever
Remote
Chute Lever
Figure 13
WARNING: Never run engine indoors or in an
enclosed, poor ventilated area. Engine exhaust
contains CARBON MONOXIDE, an OR-
DERLESS and DEADLY GAS.
Keep hands, feet, hair and loose clothing away from
any moving parts on engine and snowthrower.
Temperature of muffler and nearby areas can exceed
150_ F (66_ C). Avoid these areas.
DO NOT allow children or young teenagers to operate
or be near snowthrower while it is operating.