John Deere SB1274 Snow Blower User Manual


 
ASSEMBLY
OM 0391SB1274-A
14
1. Hydraulic hose
2. Cardboard
3. Ma
g
nif
y
in
g
g
lass
Installation of the Chute and the Hydraulic Rotation
(Figures 3-4-5-6-7-8)
1. Figures 3: Remove the retaining plate
(item 1) by removing the two 5/8" x 1 1/2
bolts (item2) and 5/8" serrated flange nuts
(item 3).
2. Figures 3: Remove the rotation ring
(item 4) and the gear shield (item 5) by
removing the four 5/16" x 1" serrated flange
nuts (item 6) and the 5/16" serrated flange
nuts (item 7).
3. Figure 4: Take off the motor gear (item 1)
by removing the bolt, the lockwasher and
the flat washer (items 2-3-4).
4. Figure 4: Remove the four bolts,
lockwashers and flat washers (items 5-6-7)
the remover the hydraulic motor (item 8)
making sure the key (item 9) remains in the
motor shaft.
5. Figure 4: Remove the anchoring plate
(item 10) and the anchoring flat bar
(item 11).
To avoid serious personal injury. Escaping
hydraulic/ diesel fluid under pressure can
penetrate the skin causing serious injury
.
Do not use your hands to
check for leaks. Use a
piece of cardboard or
paper to search for leaks.
Stop engine and relieve pressure before
connecting or disconnecting lines.
Tighten all connections before starting
engine or pressurizing lines.
If any fluid is injected into the skin, obtain
medical attention immediately or gangrene
may result
CAUTION
Figure 4
Figure 3