Filter
Top Products
REMOVING
Removing - Page 11
A
C
B
Removing tiller with Quick Coupler
1. Raise tiller.
2. Put parking stand (A) in the DOWN position:
Install spring locking pin (C) in order to secure parking
stand (A) to the tiller bracket (B).
3. Lower tiller to the ground.
4. Disconnect driveline from tractor by pulling back on
coupler to release it from the LOCKED position.
5. Raise the two Quick Coupler levers (D) to unloch
tiller
(Quick Coupler figure, page 9).
6. Lower Quick Coupler till further free the tiller.
7. Drive tractor forward slowly.
Only skid version