Filter
Top Products
Service lubrication
WARNING: • Firmly block tiller on horizontal surface.
• Always keep oils and greases well away from children’s reach.
• Always thoroughly read the warnings and precautions indicated on the
containers. Avoid contact with the skin.
• Always thoroughly and fully wash after use. The utilized oils should be
treated in compliance with the current anti-pollution laws.
A
B
A
Every 8 work hours
• Grease the cardan shaft cross journals (A) and (B).
• Check that the bolts fixing the hoe blades (H) are well
tightened.
• Grease the rotor spindles (C).
Every 50 work hours
• Check the level of the oil in the gearbox or in the reduction
unit (D) and top off to the level mark on the rod as necessary.
• Side transmission gears: check the level of the oil in the
side casing of the transmission unit, unscrewing the level
plug (G) and checking that oil flows out.
Add oil through the fill plug (E) if necessary. It should flow
from the level plug.
Every 400 work hours
• Change the oil in the reduction unit and transmission casing
by completely draining off the old oil through the drain plug
under the reduction unit and through the transmission drain
plug.
SERVICE LUBRICATION
Service Lubrication - Page 18