Filter
Top Products
• Means of dispatch. If this item is not indicated, the Manufacturer, while dedicating particular care to this
service, shall not be held responsible for delays in delivery caused by cases of force majeure.
Transport expenses shall always be at the consignee’s charge. The goods travel at the purchaser’s risk
and peril even when sold ex destination.
NOTE: The terms right or left indicated in the descriptions refer to the implement when viewed from
the rear side.
Lift hook assembly procedure
for model RT 1273 only
1. Remove bolts (A)
2. Untighten bolt (B)
3. Rotate lift hook on vertical position (C)
4. Tighten bolt (A) and bolt (B) to 52 Nm (38 lb-ft) tight-
ening torque.
Installing driveline on tiller
NOTE: Shield removed for clarity ONLY. ALWAYS
keep shield in place.
1. Pull coupler back and slide driveline on driveshaft until
coupler LOCKS in place.
NOTE: You should hear a clicking sound when
driveline is properly installed.
Spare parts
Spare parts should be ordered from your Dealer and
should always include the following indications:
• Type, model and serial number of the machine.
These data are punched on the data plate with which
every implement is equipped.
• Code number of the required spare part. This will be
found in the spare parts catalogue.
• Description of the part and required quantity.
• Table number.
ASSEMBLY / SPARE PARTS
Assembly - Page 29
B
C
A