Filter
Top Products
REMOVING
Removing - Page 15
A
C
B
Removing tiller
1. Raise tiller.
2. Put parking stand (A) in the DOWN position:
Install spring locking pin (C) in order to secure parking
stand (A) to the tiller bracket (B).
3. Lower tiller to the ground.
CAUTION: Before you work around hitch:
• STOP engine.
• LOCK park brake.
• FIRMLY block tiller on horizontal surface
.
4. Disconnect driveline from tractor by pulling back on
coupler to release it from the LOCKED position.
5. Remove quik-lock pin (D) and drilled pin (E) from
center link (F).
NOTE: Put quik-lock pins and driller pins back into
brackets on tiller for storage.
6. Remove draft links (J) from draft link brackets (G) by
removing quiklock pins (H) and drilled pins (I).
NOTE: Put quik-lock pins and driller pins back into
brackets on tiller for storage.
7. Drive tractor forward slowly.
Removing tiller with Quick Coupler
1. Raise tiller.
2. Put parking stand (A) in the DOWN position:
Install spring locking pin (C) in order to secure parking
stand (A) to the tiller bracket (B).
3. Lower tiller to the ground.
4. Raise the two Quick Coupler levers (D) to unloch
tiller (Quick Coupler figure, page 14).
5. Lower Quick Coupler till further free the tiller.
E
F
E
F
D
RT 1173 - 1181
RT 1273
D
F
E
D