Operating - 21
OPERATING
2. Lower mower deck to desired cutting height position.
NOTE: Throttle lever should be at full throttle position before
engaging mower to avoid stalling engine.
3. Push throttle lever up to the full throttle position.
4. Engage mower.
• On models with electric attachment engagement switch: Pull switch
up.
• On models with mechanical attachment engagement lever: Push lever
forward.
NOTE: The mower and engine will stop as the reverse foot pedal is
pressed for Automatic Transmission or when the gear shift lever is
moved to the R (reverse) position for Gear Transmission with mower
engaged.
5. Disengage mower blades before moving in reverse or stopping engine.
• Machines with mechanical attachment engagement lever: Pull lever
back.
• Machines with electric attachment engagement switch: Push switch
down.
Using Mulch Cover (107 cm (42 in.) and 122 cm (48 in.)
Mower Decks (If Equipped)
NOTE: Optional mulch cover must be purchased from dealer.
NOTE: Remove mulch cover for side discharge operation.
MX10441Y
Picture Note: 122 cm (48 in.) used for illustration.
1. Raise discharge chute (A) and metal deflector (B).
MX10440Y
2. Install mulch cover (C) onto mower deck (D). Mulch cover lip (E) must
be seated in mower deck groove.
3. Hook mulch cover to mower deck:
• On 122 cm (48 in.) deck, wheel bracket grooves (F).
MX8868Y
• On 107 cm (42 in.) deck, slot (G) on left side and wheel bracket hole
(H).
4. Lower discharge chute and metal deflector.
5. Make sure bagger blades are not installed for maximum mulching
operation.
Using Wash Port to Clean Mower Deck
NOTE: Follow this procedure after each use to prevent buildup and
remove corrosive lawn chemicals.
1. Park machine safely. (See Parking Safely in the Safety section).
c CAUTION: Avoid injury! Rotating blades are dangerous.
Before adjusting or servicing mower:
• Disconnect spark plug wire(s) or battery negative (-) cable to
prevent engine from starting accidently.
• Always wear gloves when handling mower blades or working
near blades.
A
B
E
F
D
C
H
G