Filter
Top Products
MAINTENANCE
26
MTF−051055L
HOW TO REMOVE THE SNOW HOOD
To access the spark plug, the snow hood must be removed
as follows:
1. Remove the choke control knob (see Figure 25).
2. Remove the safety key.
3. Remove the mounting screws (see Figure 26).
4. Slowly remove the snow hood. Make sure that the prim-
er button hose and the ignition wire are not discon-
nected.
5. The spark plug can now be accessed.
6. To install the snow hood, first make sure that the primer
button hose and the ignition wire are connected.
7. Mount the snow hood to the engine and secure with the
mounting screws (see Figure 26).
8. Connect the choke control knob with the choke shaft on
the carburetor (see Figure 27 and Figure 28). Make sure
the choke control knob is properly installed. If the choke
control knob is not installed correctly, the choke will not
operate.
9. Install the safety key.
Figure 25
Choke Control
Knob
Safety Key
Figure 26
Snow Hood
Mounting Screws
Primer Button
Hose
Ignition
Wire
Spark
Plug
Figure 27
Choke Control Knob
Choke Shaft
Figure 28
Carburetor
Safety Key