Filter
Top Products
Service Mower - 43
SERVICE MOWER
Replacing Mower Drive Belt (42 (3 in 1))
1. Park machine safely. (See Parking Safely in SAFETY
section.)
2. Remove mower deck.
3. Remove drive belt.
MX10511
a. Remove three capscrews and belt shield (A).
b. Loosen sheaves (B) and belt guides (C).
c. Remove mower belt.
4. Inspect belt for wear or damage; replace as necessary.
5. Clean top surface of mower deck and sheaves.
MX10512
6. Install belt on mower deck as shown. Make sure belt is
in the groove of each sheave and inside belt guides (D).
7. Tighten sheaves to 47 N•m (35 lb-ft).
8. Install belt shield(s).
9. Install mower deck.
10.Adjust mower belt tension and spindle brakes, if
necessary.
Replacing Mower Drive Belt (48 (3 in 1))
1. Park machine safely. (See Parking Safely in SAFETY
section.)
2. Remove mower deck.
3. Remove drive belt.
MX10505
a. Remove seven capscrews and left and right belt
c CAUTION: Avoid injury! Rotating blades are
dangerous. Before adjusting or servicing
mower:
• Disconnect spark plug wire(s) to prevent
engine from starting accidently.
• Always wear gloves when handling mower
blades or working near blades.
A
B
C
c CAUTION: Avoid injury! Rotating blades are
dangerous. Before adjusting or servicing
mower:
• Disconnect spark plug wire(s) to prevent
engine from starting accidently.
• Always wear gloves when handling mower
blades or working near blades.
D
D