Filter
Top Products
and needs to be shortened. Contact your local dealer if it is determined that the
driveline is too short for your tractor.
1.05 - Quick Hitch Adapter Assembly and Operation
Using an iMatch/Quick Hitch system:
The GM1 series mowers can be used with an iMatch/Quick Hitch system, allowing for
quick and easy hookup, by installing an optional adapter. This optional adapter has
floating yokes that will allow the mower to follow the contour of the ground.
WARNING: When using an iMatch/Quick Hitch on a PTO driven implement always
ensure there is the proper driveline overlap prior to use. If there is not the
minimum 6” overlap do not use and contact your nearest dealer to purchase a
longer driveline.
iMatch/Quick Hitch Adapter assembly (see fig. 4):
1. Remove hitch pins from grooming mower’s linking plates.
2. Remove M16x140 bolt on top of the three point hitch of the grooming mower.
3. Remove M20x45 bolts that hold the top hitch supports to the linking plates of the
mower.
4. Attach the floating yokes of quick hitch adapter assembly to the linking plates of the
mower. Note: Two ½” long bushings for the floating yokes are provided in the
hardware bag of the quick hitch adapter kit. Ensure these spacers are installed onto
the M16x60 bolt.
GROOMING MOWERS OPERATOR’S MANUAL
GENERAL INFORMATION 7 FRONTIER
procedures for shortening the driveline.
8
3
2
5
Fig. 3
3. top hitch support
5. top hitch arm
2. top hitch plate
8. rear support plate