Filter
Top Products
Always sit in power unit seat when operating
controls or starting engine. Securely fasten seat
belt, place transmission in neutral, engage brake,
and ensure all other controls are disengaged before
starting power unit engine.
Operate tractor PTO at 540 RPM. Do not exceed.
Do not operate PTO during transport.
Look down and to the rear and make sure area is
clear before operating in reverse.
Do not operate or transport on steep slopes.
Do not stop, start, or change directions suddenly
on slopes.
Use extreme care and reduce ground speed on
slopes and rough terrain.
Watch for hidden hazards on the terrain during opera-
tion. Stop power unit and equipment immediately upon
striking an obstruction. Turn off engine, remove
key, inspect, and repair any damage before
resuming operation.
Leak down or failure of mechanical or hydraulic
system can cause equipment to drop.
• Maintenance
Before dismounting power unit or performing any
service or maintenance, follow these steps: disengage
power to equipment, lower the 3-point hitch and all
raised components to the ground, set parking brake,
stop engine, remove key, and unfasten seat belt.
Before performing any service or maintenance,
disconnect driveline from tractor PTO.
Do not modify or alter or permit anyone else to
modify or alter the equipment or any of its components
in any way.
Always wear relatively tight and belted clothing to
avoid getting caught in moving parts. Wear sturdy,
rough-soled work shoes and protective equipment
for eyes, hair, hands, hearing, and head; and respirator
or lter mask where appropriate.
Make sure attachment is properly secured, adjusted,
and in good operating condition.
Keep all persons away from operator control area
while performing adjustments, service, or
maintenance.
Never go underneath equipment (lowered to the
ground or raised) unless it is properly blocked and
secured. Never place any part of the body under
neath equipment or between moveable parts even
when the engine has been turned off. Hydraulic system
leak down, hydraulic system failures, mechanical
failures, or movement of control levers can cause
equipment to drop or rotate unexpectedly and cause
severe injury or death. Follow Operator’s Manual
instructions for working underneath and blocking
requirements or have work done by a qualied dealer.
Make certain all movement of equipment components has
stopped before approaching for service.
Tighten all bolts, nuts, and screws to torque chart
specications. Check that all cotter pins are installed
securely to ensure equipment is in a safe condition
before putting unit into service.
Make sure all safety decals are installed. Replace if
damaged. (See Safety Decals section for location.)
Make sure shields and guards are properly
installed and in good condition. Replace if damaged.
• Storage
Block equipment securely for storage.
Keep children and bystanders away from storage area.
Follow manual instructions for storage.
Always use a tractor to position equipment for storage.
Never attempt to move equipment by hand.
SAFETY RULES
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
Safety 7