John Deere AC-G4010H Portable Generator User Manual


 

18 Operator’s Manual
SHUTDOWN
1. Remove all load by turning off electrical appliances and
unplugging electric cords.
2. Allow engine to run at idle speed or at no load condition to
cool for two (2) minutes.
NOTE: 

3. Turn engine key or ignition switch off.
4. Close fuel valve on unit or engine.
CONTROLS
CONTROL PANEL:
The generators are equipped with the following items:

- Circuit Breaker
- One 125 Volt, 20 Amp, GFCI protected receptacles.

- Full Power Switch
- Circuit Breakers
- Two 125 Volt, 20 Amp, Duplex (2 outlets), GFCI protected
receptacles.
- One 125 Volt, 30 Amp, Locking Type Receptacle.
- One 125/250 Volt, 20 Amp, Locking Type Receptacle.
NOTE: 




WARNING: NEVER EXCEED THE RATING OF A
RECEPTACLE. These receptacles are
protected against overloads by resetting
magnetic type circuit breakers. If a circuit
breaker trips, the cause should be determined
and corrected prior to continuing use.