Filter
Top Products
GreenStar guidance
Parallel Tracking
• Reduces overlap and skips
• Improves efficiency – saves time, chemicals,
and fuel
• Adjusts for satellite drift for precise applications
• Available on most equipment with 12-volt power
• Use on contours and with all three signal options
(SF1, SF2, and RTK)
AutoTrac
• Saves money, reduces fuel costs
• Increases field operating speeds
• Can help increase yields with more accurate
seed, fertilizer, and chemical placement
• Improves efficiency by maximizing full width
of implement
• Reduces operator fatigue
AutoTrac RTK
• Accurate guidance system
• Reduces input costs
• Improves efficiency
• Reduces operator fatigue
The original
GreenStar system
provides an
affordable option
for guidance
and field
documentation
applications.
GreenStar 2 system
Reconfigurable GreenStar 2 display (above) with touch-screen navigation.
It comes pre-loaded with ISOBUS functionality, parallel tracking, and basic field
documentation programs to boost productivity. It can also act as a tractor per-
formance monitor, providing you with instantaneous ground speed, wheel speed,
rear PTO speed, fuel efficiency, distance, total area, fuel consumption, engine
load readings, and more. With the GreenStar 2 Display, your 9030 Series Tractor
is fully prepared to optimize machine performance (guidance applications and
performance monitor), document all critical field tasks electronically (Field
Doc
™
), and control ISOBUS compatible implements.
Signal accuracy options
• SF1 – Free, pass-to-pass accuracy of about 1 ft.
•
SF2 – Pass-to-pass accuracy of ± 4 in.
•
StarFire RTK – ± 1-in. accuracy
Note: SF1 and SF2 – 15 minutes pass-to-pass, 95 percent of the time.
RTK ± within 6 mi. of base station and 68 percent of the time.
StarFire
™
iTC
™
position receiver
with Integrated Terrain
Compensation corrects
all position calculations
to adjust for uneven
ground and slopes.
Make every pass more
productive with integrated
guidance from John Deere
Ag Management Solutions.
Start with Parallel Tracking
™
and the free SF1 signal. This
hands-on system reduces
implement overlap and is ideal
for broad-acre tillage, seeding,
and spraying.
Ready for hands-free guidance?
Then upgrade to AutoTrac assisted
steering. It works with the free SF1
signal for broad-acre applications
or the subscriber-based SF2 signal.
It gives you pass-to-pass accuracy
of ± 4 in.
AutoTrac helps you work fast
so you finish more acres in less
time. Plus, by minimizing implement
overlap and skips, you can
decrease fuel, seed, chemical,
and fertilizer costs.
Visit your local John Deere
GreenStar certified dealer and
see how guidance can pay in
your operation.
John Deere offers you a complete zone-tillage
solution (left) with the all-new 2510S Strip-Till
Nutrient Applicator and AutoTrac RTK guidance.
You get repeatable 1-inch accuracy pass after
pass, season after season.
Guidance benefits
• Reduce operator fatigue
• Save fuel with less overlap
• Increase operating speed
• Minimize crop input loss
Make each pass more efficient with a GreenStar guidance system
10 Ag Management Solutions 11