Filter
Top Products
10 iRobot Mirra 500 Series Owner’s Manual
4
1. Place the power supply (transformer) at least 3.6 meters / 11.8 feet
from the pool and atleast 12 cm / 4 Inch above the surface.
The transformer will supply low voltage to the cleaner.
2. Uncoil the cable.
4. Plug the cable into the power supply. Make sure the key on the plug corresponds
exactly with the key slot on the socket of the power supply.
(See details on the next page)
5. Plug the power supply into a grounded outlet. Ensure that the electric outlet has
been properly grounded.
6. Press the CLEAN button and the light will glow indicating that the system is
“ ON ” and the pool cleaner will start the cleaning cycle.
3. Place the unit in the water.
Turn the unit side to side
in the water to allow air to
escape from the body
and then let the cleaner
sink to the bottom of the
pool. Then, spread the cable
over thesurface of the pool
asevenly as possible.
Operating Your Pool Cleaner - Set Up
IMPORTANT:
Please be sure to always keep your pool cleaner properly stored anywhere
between 10 to 40 degrees Celsius (50 to 104 degrees Fahrenheit). This will
keep the motors, plastics and seals protected.
Robot can be used in water with temperatures ranging from 13°C to 35°C
(55°F to 95°F). However, the recommended optimal temperature is between
22°C and 32°C (72°F and 90°F)
1a
12 cm
(4.7 inch)
3.6m/11.8ft
1
2
3
4