Filter
Top Products
6
2. Telescope Assembly
Step 1. Preparing the Tripod
Unlock the tripod leg locks (#10).
Extend tripod legs.
Lock the leg locks afterwards.
Step 2.
Pull tripod legs apart to a fully opened position.
Turn the center tripod lock knob (#9) to secure the tripod. Tighten to a
firm feel.
Caution
: Make sure you loosen this lock knob before collapsing
the tripod to store away.
Step 3. Attaching the Mount
Attach mount to tripod by placing the mount onto the threaded on
tripod. Then turn the mount until it is securely fastened to the tripod.
Use height adjustment handle (#8) to adjust the height of the mount if
needed. (Caution
: Do not extend beyond 6 inches.)
Make sure to tighten the tripod height extender lock (#12).
Step 4. Installing Batteries (not included)
Pull the batteries compartment cover (shown) open.
Gently pull the batteries holder (shown next) out of the compartment to
avoid breaking the attached wires.
Step 4a.
Insert 8 AA batteries (not included) according to the diagrams on the
holder.**
Replace the holder back into the batteries compartment and replace the
cover.
Note
: fit the batteries holder back into the compartment with the
attached wires at the bottom right corner (see arrow in the photo).
** Use only fresh batteries; do not mix fresh and old
batteries;insufficient battery power may cause error
messages;optional AC Adapter and Car Charger accessories are
available at www.ioptron.com
Threaded
bolt
Height lock
(#12)
#10
#9