Filter
Top Products
MiniPier for iEQ45/iEQ30
The assemble example shown here is for installing a MiniPier onto an iEQ45 tripod. For an
iEQ30 mount, either an iEQ45 tripod or a MiniTower/MiniTower Pro tripod is needed.
1. Extend the tripod legs and adjust the height of the tripod. Secure the tripod. Remember that
the MiniPier will add 8 inch in height. Remove the alignment peg from the iEQ45 tripod head.
2. Release three locking screws located at the bottom of the MiniPier body. Put the Base
Flange onto the tripod head. Using two M8 hex head screws to secure the base flange on to
the iEQ45 tripod.
3. Put the MiniPier body onto the Base Flange and secure it using three locking screws.
4. Final adjust the tripod height and level the tripod with MiniPier before mounting the iEQ45
mount.
M8 screw
Lockin
g
screw