Filter
Top Products
IMPORTANT SAFETY NOTICE
This play ground equipment is built for optimum safety. However, certain precautions apply
whenever you operate a piece of play ground equipment. Be sure to read the entire manual
before you assemble or operate your equipment. In particular, note the following safety
precautions to reduce the likelihood of serious or fatal injury.
1. Children must be supervised at all times and never left unattended with the unit.
2. Do not install the equipment over concrete, asphalt, packed earth, or any other hard
surface. A fall onto a hard surface can result in serious injury to the user.
3. Make sure the surfaces, either indoors or outdoors, are free of objects that may cause
tipping over.
4. Place the equipment on level ground, not less than 6 ft (1.8 m) from any structure or
obstruction such as fence, garage, house, overhanging branches, laundry lines, or
electrical wires.
5. Make sure bystanders are at least 5 feet away from the equipment while it is in motion. No
one should be allowed to walk close to, in front of, behind of, or between moving items.
6. Keeps hands and feet away from the pivot area.
7. Do not get off from seat while it is in motion.
8. Do no stand on the teeter-totter. This could cause damage to the ride and result in injury.
9. Do not swing with empty seat.
10. Children should not wear loose clothing. Attire should include well-fitting shoes.
11. This teeter totter is intended for use by children from ages 3 to 13.
12. Maximum weight capacity 300 lbs.
13. Only two people should be using the equipment at the same time.
14. Impact-absorbing material must be placed around the teeter totter. Please refer to the
PLAYGROUND SURFACING MATERIALS in page 4.
15. Maximum fall height: 35 inches.
16. To prevent serious injury, children must NOT use the equipment until properly installed.
17. To prevent serious injury, parents must warn children not to use this equipment in a
manner other than intended.
18. To prevent serious injury, parents must warn to children not to attach items to the
equipment that are not specifically designed for use with the equipment.
Care and Maintenance
1. Periodically inspect all parts. Check all nuts and bolts twice monthly during the usage
season for tightness and tighten as required. It is particularly important that this
procedure be followed at the beginning of each season.
2. Replace any worn and damaged part immediately. Check all coverings for bolts and
sharp edges twice monthly during usage season to be certain they are in place. Replace
when necessary. It is especially important to do this at the beginning of each new
season.
3. Cover the equipment with tarp when left outdoor.
4. Use mild household spray cleaners and/or a damp rag to wipe clean. Do not use harsh
cleaning chemicals.
5. Sand rusted areas on tubular members and repaint using a non-lead based paint
meeting the requirements of Title 16 CFR Part 1303.
6. Disposal Instructions – The equipment can be safely disassembled and disposed without
unreasonable hazards. Call your local recycle agency regarding details of recycling.
SAVE THESE INSTRUCTIONS.
3