Filter
Top Products
18
ATTACHING AND REMOVING THE ACCESS PANEL
T
urn off the spa power. Remove the eight #10 x 2”
Machine Screws (37) that secure the indicated Access
Panel (25) to the spa. Carefully remove the
Access
Panel until the CD wire harness (not shown) is visible
and disconnect it. Set the Access Panel aside.
Be
careful not to damage the spa shell.
To replace the Access Panel (25), hold the Access
Panel in place, connect the CD wire harness to the
CD Player and reattach the Access Panel to the spa
with the eight #10 x 2” Machine Screws (37). Be
careful not to overtighten the Screws.
DRAINING THE HYDROTHERAPY SPA
The hydrotherapy spa should be drained at least four
times per year and refilled with clean water. You may
need to drain the spa more often, depending on the
user load. This must be done because after repeated
chemical treatment the water becomes chemically
saturated. Once this happens, additional chemical
treatment of the water is no longer ef
fective.
The spa
should also be drained if you will not be using it for
long periods of time. The spa must always be drained
before major repairs are made.
The hydrotherapy spa should always be covered
when it is empty
. Direct sunlight can cause exten-
sive damage. The surface of the spa shell can
reach temperatures as high as 150°F in a matter
of minutes if exposed to the sun while it is empty.
These high temperatures can cause significant
damage, such as blistering of the shell surface
and warping of the spa shell. Any damage caused
by sun exposure is not covered under warranty
.
To drain the hydrotherapy spa, follow the steps below:
1.
Using the console, adjust the temperature to the
lowest setting.
2.
Shut off the power to the spa, at the circuit break-
er or GFCI.
3. Remove the access panel from the spa (see
ATTACHING AND REMOVING THE ACCESS
PANEL on this page).
4. Pull the drain hose out and hold it above the
waterline. Remove the cap, open the valve knob,
and attach a garden hose to the drain hose. Lower
the drain hose and drain the spa.
5. When the spa is empty, remove the garden hose,
close the valve knob, and reattach the cap and
return the drain hose inside the spa.
6. Reattach the access panel.
7. Refill the spa and treat the water with chemicals
(see pages 12 and 17).
25
37
37
Drain
Hose
Valve
Knob
Cap