Filter
Top Products
9
5. After a qualified electrician has wired the spa to a
240 volt power source, refer to the inset drawing.
Set the Filter (16) into the filter housing. Next, screw
the Filter Cover (8) into the filter housing until it is
fully seated.
Remove the two warning decals (not shown) from
the spa shell. Using a damp cloth, wipe the spa shell
clean. Before filling the spa, make sure that it is
in the desired position and that there is room to
easily service the spa. Once the spa is filled, it
will have to be drained before it can be moved.
Using a garden hose or other clean water source,
begin filling spa. Do not use soft water. The spa
may be filled with cold water; however, if warm or
hot water is used, the spa will be ready for use
sooner. Fill the spa until the water is at the level
shown at the right. Do not overfill the spa.
3. Refer to the drawing on page 6 and locate the
heater access opening.
Locate the two indicated gate valves inside the
heater access opening. Make sure that the gate
valves are open and that the locking clips are
snapped onto the stems of the gate valves (refer to
the inset drawing in step 2 on page 8).
Make sure that the four indicated collars are tight-
ened.
Refer to step 1. Re-attach the heater Access Panel
(5) to the spa with the four 1/4” x 1 1/2” Machine
Screws (7).
4. The hydrotherapy spa operates on a 240 volt power source and must be wired directly to a 240 volt ground
fault circuit interrupter (GFCI) installed in your home. This procedure must be performed by a qualified
electrician. A wiring diagram is found on the inside of the electronics pack as a reference. Under no
circumstances should the spa be wired by someone other than a qualified electrician. Before you
have the spa wired, make sure that it is in the position you want, and that it can be easily serviced, if needed.
6. Pull down one of the straps on the Spa Cover (11)
and hold the Buckle (30) against one of the
WeatherWood™ panels on the spa. (Note: To posi-
tion the Buckle correctly, have a second person hold
the strap on the opposite side of the Spa Cover
tight.) The Spa Cover must be tight. Do not place
the Buckle over the grooves between the
WeatherWood™ panels. Refer to the inset drawing.
Remove the latch from the Buckle (30). Attach the
Buckle to the WeatherWood™ panel with two #4 x
3/4” Screws (31).
Attach the other five Buckles (30) to the
WeatherWood™ panels in the same way.
Remove the Spa Cover (11) from the spa.
5
3
Fill to Here
Filter
Housing
Collar
Collar
Collar
Gate
Valve
Electronics Pack
Gate
Valve
6
11
30
Strap
Strap
Latch
30
31
8
16
Filter
Housing