Filter
Top Products
12-12 108604 10/08
Before attempting any failure diagnosis of the electrical system, use a test light or voltmeter to check the
battery voltage. If the battery voltage is satisfactory, check the cleanliness and tightness of the terminals
and ground connections. A general understanding of electrical servicing and use of basic test equipment
is necessary for troubleshooting and repair.
Major overhaul or repair of the starting motor or charging system should be performed by trained
technicians only.
ACCESS TO ENGINE AND HYDRAULIC PUMPS
The hydraulic pumps are accessed by lifting the seat platform. The seat platform is hinged at the front. To
raise it, release seat latch and tilt seat platform up and forward.The seat platform catch ("FIG. 5") will
prevent the seat from going all the way over. However, if more access is desired under the seat platform,
the seat platform catch can be raised allowing the seat to pivot more. Make certain to place the control
arms in the park brake position and pivot the arm rests upward before placing the seat platform in
the full forward position to prevent arm rest damage.
WARNING: Always wear adequate eye protection when servicing the hydraulic system and battery.
HYDRAULIC SYSTEM
IMPORTANT: Never use hydraulic or automatic transmission fluid in this system; use only motor oil as
specified. Remember, dirt is the primary enemy of any hydraulic system.
WARNING: Hydraulic oil escaping under pressure can penetrate skin. Hydraulic oil may cause infec-
tion in a minor cut or opening in the skin. If exposed to hydraulic fluid, see a doctor at once.
Before applying pressure to hydraulic system, make sure all connections are tight and all hoses and lines
are in good condition. To find a leak under pressure, use a piece of cardboard or wood — never use your
hands. Relieve all pressure in the system before disconnecting or working on hydraulic lines. To relieve
pressure, lower all attachments and shut off engine.
The 1.0 U.S. gallon (3.79 liter) hydraulic reservoir is located in front of the engine and under the operator’s
platform "FIG. 6".
Check oil level in hydraulic system after every 50 hours of operation or weekly, whichever occurs first.
Check more often if system appears to be leaking or otherwise malfunctioning.
Fluid level should be 1” from top of reservoir. Use only SAE 10W40 SG, SF/CC, CD service motor oil.
Change hydraulic system filter element ("FIG. 6") after first 50 hours of tractor operation, then replace filter
and oil in reservoir every 500 hours thereafter. When changing hydraulic oil use 1/2 unit (approximately
3.5 oz.) of Lubrizol additive (Hustler P/N 027912). This additive, available from your Hustler dealer, will
increase the performance life of the hydraulic system components.
FIG. 5
SEAT PLATFORM
CHECK
SEAT PLATFORM
CONTROL LEVER