Husqvarna Z 246i Lawn Mower User Manual


 
1
2
Read the Safety section and following pages, if you are
unfamiliar with the machine.
Training
Due to unique steering capabilities, zero turn mowers are far
more maneuverable than typical riding mowers.
This section should be reviewed in its entirety prior to
attempting to move the mower under its own power. When
first operating the mower or until becoming comfortable with
controls, use a reduced throttle speed and reduced ground
speed. DO NOT move control levers to the furthest forward or
reverse positions during initial operation.
First time users should become familiar with the mower’s
movement on a hard surface, such as concrete or blacktop
PRIOR to attempting to operate on turf. Until the operator
becomes comfortable with the mower controls and zero turning
capability, overly aggressive maneuvers may damage turf.
Steering
To move forward and backward
The direction and speed of the mower’s movements are
effected by the movement of the control lever(s) on each side
of mower. The left control lever controls the left wheel. The right
control lever controls the right wheel.
First time users should push the mower (see Moving the
Machine By Hand in the Operation section) to an open, flat
area without other people, vehicles or obstacles nearby. To
move the unit under its own power, the operator must sit in the
seat and start the engine (see Before Starting in the Operation
section). Adjust the engine speed to idle and disengage the
park brake by moving the steering control levers inward. Do
not engage the blades. As long as the control levers have not
been moved forward or backwards, the mower will not move.
Slowly move both control levers slightly forward. This will allow
the mower to move forward in a straight line. Pull the control
levers back to the neutral position and the mower should stop
moving.
Pull back slightly on control levers, allowing the mower to
move backwards. Push the control levers forward to the neutral
position and mower should stop moving.
To turn to the right
While moving in a forward direction, pull the right lever back
towards the neutral position while maintaining the position of
the left lever, this will slow the rotation of the right wheel and
cause the machine to turn in that direction.
To turn to the left
While moving in a forward direction pull the left lever back
towards the neutral position while maintaining the position of
the right lever, this will slow the rotation of the left wheel and
cause the machine to turn in that direction.
To zero turn
While moving in a forward direction, first pull both control
levers back until the mower stops or slows dramatically.
Then by alternating one lever slightly to the forward position
and the other in the reverse position, complete the turn.
SmartSwitch Ignition
NOTES: The default passcode [321] is preset at the factory. For
safety and security, the passcode should be changed prior to
use.
Resetting ignition system passcode
1. To initialize the ignition system, press the START/STOP
(S/S) button on the ignition switch or sit on the seat. The
blue indicator will blink, showing the system is operational.
2. Using the lower buttons, press and hold the (1) and (3)
buttons at the same time for three seconds. The blue
indicator will then be lit continuously, signalling the system
is ready to accept a new code.
3. Using the lower buttons, enter a desired code of numbers
from one to five digits and then press the S/S button. The
indicator will blink green to signal the passcode has been
accepted.
4. If the S/S button blinks red, the passcode reset has not
been accepted. Wait for the S/S button to return to blinking
blue and retry the programming, starting at Step 1.
17
OPERATION