Husqvarna Z5426 Lawn Mower User Manual


 
English-43
MAINTENANCE
Deck belt installation
NOTE: For ease in installing the deck belt,
refer to the routing decal on bottom of seat.
Wrap the deck belt around the electric
clutch pulley that is located on the engine
shaft.
Route the belt forward between the EZT
(E-Series Zeroturn Transaxles) and up
onto the deck.
Place belt around spring loaded idler
pulley, between the pulley and guide.
Secure bolt and nut.
Starting on the right hand side of the
deck, wrap the belt around the stationary
idler pulley, the right mandrel housing,
then around to the left mandrel housing.
Push inward on the idler arm and
carefully route belt over stationary idler
pulley. Once belt is properly routed,
slowly release idler arm to tension belt.
Double check belt routing to make sure it
matches the routing decal, and the belt
does not have any twist. Correct as
needed.
Replace belt shields on both mandrel
housings and secure with fasteners.
1
1. Clutch pulley
Belt routing, deck belt