Filter
Top Products
22
SERVICE AND ADJUSTMENTS
FIG. 26
D
C
G
E
F
M
L
K
R
Q
A
P
G
B
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 26)
1. Park tractor on a level surface. En gage parking
brake.
2. Lower attachment lift lever to its lowest position.
4. Remove any dirt or grass clippings which may have
accumulated around mandrels and entire upper deck
surface.
5. Remove belt from clutch pulley (M), both mandrel pul-
leys (R) and all idler pulleys (S).
MOWER DRIVE BELT INSTALLATION
1. Install belt around both mandrel pulleys (R) and around
idler pulleys (S) as shown.
2. Install belt onto clutch pulley (M).
IMPORTANT: Check belt for proper routing in all mower
pulley grooves.
3. Raise attachment lift lever to highest position.
TO REPLACE MOTION DRIVE BELT
(See Fig. 25)
Park the tractor on level surface. En gage parking brake.
For as sis tance, there is a belt installation guide decal on
bottom side of left footrest.
BELT REMOVAL -
• Remove mower (See “TO RE MOVE MOWER” in this
section of manual).
NOTE: Observe entire motion drive belt and position of all
belt guides and keepers.
• Disconnect clutch wire harness (A).
• Remove anti-rotation link (B) on right side of tractor.
• Remove belt from stationary idler (C) and clutching
idler (D).
• Remove belt from centerspan idler (E).
• Pull belt slack toward rear of trac tor. Carefully remove
belt up wards from trans mis sion input pulley and over