Filter
Top Products
SERVICE AND ADJUSTMENTS
22
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located in the engine compartment, directly
in front of the dash.
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the backside of the
grill.
• Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting.
• Check wiring. See the electrical wiring diagram in the
Repair Parts section of this manual.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 30)
• Lift hood. Disconnect headlight wire connection.
• Remove wing nuts on inside of side panels.
• Pivot hood and side panel forward and lift off tractor.
• To replace, reverse above procedure.
WINGNUT (INSIDE)
WIRE CONNECTION
FIG. 30