Husqvarna XOUS2009 Blower User Manual


  Open as PDF
of 21
 
11
1. Position upper chute support against bagger inlet,
ushatouteredges.SeeIllustration.
2. Using support as a template, drill two
3
/8 holes into
bagger hood.
Upper Chute Support
Bagger Inlet
Nut
Bagger Hood
Flat Washers
Hex Bolt
Flex Trim
3. Secure upper chute support to hood with hex
bolts, washers and nyloc nuts.
ASSEMBLY
8
INSTALLING CHUTE SUPPORT
3½ Bolt
WeightBracket
Weight Assembly
1. Boltcastweighttoweightbracketsusing
3
/8-16 x 3
bolts and four nuts.
2. Slidebothweightbracketsoverthefronttubeon
the frame. Be sure to position the weight assembly
in the center of the frame.
3. Secure with
3
/8-16 x 3½ bolts and four nuts.
Front Tube
9
INSTALLING WEIGHT KITS
3" Bolt
CAUTION
DO NOT operate mower with grass
catcher without front weights installed.
10
MOUNTING COVER ASSEMBLY
NOTE: Assistance from another person may ease
mounting the cover assembly to mower.
1. Liftandrotatecovertoalignthecoverbrackets
with support assembly tubes.
2. Slide the cover down over the support tubes until
secure.
 previous next