Filter
Top Products
MAINTENANCE
Husqvarna-33
Replacing the Fuel Filter
Replace the line-mounted fuel lter every 100 hours
(once per season) or more regularly if it is clogged.
To replace the lter:
Move the hose clamps away from the lter. Use 1.
at-nosed pliers.
Pull the lter loose from the hose ends.2.
Push the new lter into the hose ends. Position the 3.
lter with the “FLOW” arrow pointing up toward the
fuel pump. If necessary, a soap solution can be
applied to the lter ends to ease mounting.
Move the hose clamps back toward the lter.4.
8011-783
Check and clean the cooling air intake
Remove the main lter (outer lter) by pulling it out 1.
by hand.
Check the inner lter. If it appears dirty, it should 2.
be replaced. Remove the inner lter, if necessary,
by pulling it out by hand.
Clean inside of the lter housing. Wipe dry only.3.
Install the inner lter with the open end rst. 4.
Ensure that it enters its recess at the end of the
housing by pushing it in to the stop.
Install the main lter with the open end rst. 5.
Ensure that it enters its recess at the end of the
housing by pushing it in to the stop.
Replace the end cap and turn the end cover so the 6.
rubber valve is pointing downwards. Secure the
retaining clips.
8011-449
Installing the main lter
8011-450
Installing the inner lter