Husqvarna W4815 Lawn Mower User Manual


 
10
Operating Instructions
BEFORE OPERATING
Be thoroughly familiar with all controls and how to use
them before operating the mower. Know beforehand
how to stop the engine, drive wheels, and mower
blades in preparation for possible emergency.
EMERGENCY STOP
Pull both traction levers firmly against handle grips
and hold them securely in place. Use thumb latches
to lock both traction levers in neutral position, then
stop engine by pulling throttle control back to the off
position. See figure # 7.
NORMAL OPERATING STOP
1. Pull both traction levers firmly toward the handle
grips to stop forward motion.
2. Use thumb latches to lock traction levers in the
neutral position.
3. Move the throttle control to the slow position.
4. Move blade engagement lever to the off position.
5. Move shift lever to the neutral position.
6. Stop engine by pulling throttle control lever all the
way back to the off position.
NOTE
CLOSE FUEL VALVE AT THE END OF
EACH MOWING JOB !!
PRE-START CHECKLIST
Make the following checks and perform the services
as required before each start up.
1. If required make cutting height adjustments and
drive linkage adjustments. Refer to pages 5 and 6
2. Check tires for proper inflation (front caster tire
pressure to be 50 lbs max. / rear tire pressure to be
14 lbs max.
3. Check guards, deflectors, and covers to make sure
all are in place and secure.
4. Check blade belts for wear and correct tension if
worn or damaged, replace with original part.
5. Clean interior and exterior surfaces of the cutting
deck and clean engine of any accumulation of dirt or
debris. Keep engine air intake clear at all times.
6. Check engine oil add if needed (do not overfill)
refer to engine manual for oil specs.
7. Add fuel to tank after pushing the mower outside
where fumes can dissipate. Make sure cap is tight
after refueling.
NOTE
DO NOT ADD FUEL WHILE ENGINE
IS RUNNING OR WHILE ENGINE IS HOT.
NOTE
USE FRESH, CLEAN, LEAD FREE
GASOLINE. DO NOT USE GASOLINE
THAT HAS BEEN STORED FOR LONG
PERIODS. LEADED GASOLINE OR
GASOHOL IS NOT RECOMMENDED.
STARTING AND OPERATING
ENGINE: START ENGINE AS FOLLOWS:
1. Move blade engagement lever to the off position so
the interlock will allow engine to start.
2. Check gear shifter to be sure it is in the neutral
position.
3. While on level terrain, lock both traction levers into
the neutral position.
4. Open fuel shut-off valve
5. Set throttle control all the way forward to the choke
position.
Figure 7
HANDLE
TRACTION LEVER
NEUTRAL POSITION
THUMB LATCH
THUMB LATCH
O.P. LEVER
POINT